You are:
Private
star_border

Baumit StarTrack
Anchoring of thermal insulation by bonded joint

  • Saves energy, time and money  
  • One anchor for all insulation thicknesses
  • Without drawing of anchors on the façade
  • Anchoring of insulating boards on the EPS basis

STOP unwanted stains on the façade

Nežiadúce fľaky po kotvách na fasáde

If anchoring the thermal insulation traditionally and under certain climatic conditions, unwanted drawing of anchors on the façade occurs. We can anchor the thermal insulation to prevent this phenomenon by the adhesive anchor Baumit StarTrack. We install anchors even before bonding polystyrene insulating boards, it means directly on the wall. Individual insulating boards are bonded only afterwards. We form a perfect bonded joint between the wall and the insulating board safely anchored in the supporting base by the anchor and the high-quality adhesive.

Advantages for all

  • For the builder: The builder can always see the base to which he is going to install the anchor, there is no risk of damage, and he can also choose a suitable place so that the anchor really holds in the base.

  • For the investor: Adhesion anchors do not change regardless of presumed insulation thickness and length, or even price.

  • For all: Adhesion anchors do not disturb the integrity of insulation layer. A thermally insulated house is perfectly covered by insulation without any thermal bridges, and the façade is nice without any unwanted stains.

Simple rules – guaranteed result

Lepiace kotvy Baumit StarTrack
  • Verify the quality of base; at reconstruction, find out also thickness of the original plaster.

  • Choose a suitable type of adhesive anchor Baumit StarTrack.

  • Install the adhesive anchors Baumit StarTrach according to the prescribed pattern.

  • We recommend using the adhesive Baumit StarContact White, Baumit StarContact, Baumit openContact or Baumit ProContact for making a bonded joint.

  • At next stages of construction, follow all usual processing principles.

Adhesive anchors Baumit StarTrack

High-quality adhesive is a key

Only use of a high-quality adhesive mortar will allow to make a safe and permanent joint between a StarTrack anchor disc and an insulant that will surely transfer all stresses from the system surface to the supporting base. Our recommendation is to use an adhesive of the highest possible quality, ideally StarContact White. Enjoy your pleasure from the thermally insulated façade with adhesive anchors Baumit StarTrack without thermal bridges without any fear for a long time!

Odporúčané lepidlá

Recommended adhesives